Ubiquity Networks NanoStationM LocoM2, 2,4Ghz 802.11b/g/n 23dBm(output power) Outdoor 8dBi(gain) Mimo CPE. Used as an Access Point, Client, or Bridge for Point-to MultiPoint, Point to Point or Wireless Client. Range is 5+KM. It is an 8dBi 2x2 Mimo Panel Antena with a 23dBm Integrated Wireless Radio. Dual Linear Polarity. 60° H-pol/ 60° V-pol. AirMax airOS software. Atheros MIPS 24KC, 400MHz CPU, 32MB SDRAM, 8 MB Flash, (1)10/100 Ethernet Port, Enclosure is Outdoor UV Plastic, Max Power Consumption 5.5W, Dimension 163x31x80, included 24V, 0.5A PoE Adapter, Pole Mount Kit Included
Ubiquiti Networks NSM2 (NanostationM2), 2.4Ghz 802.11b/g/n 28dBm Outdoor 11dBi Mimo CPE. Used for Point-to MultiPoint, Point-to-Point or as a Wireless Client CPE device. Range is 13+KM. It is a 11dBi 2x2 Mimo Panel Antena with a 28dBm Integrated Wireless Radio. Dual Linear Polarity. 55° H-pol/ 53° V-pol. AirMax airOS software. Atheros MIPS 24KC, 400MHz CPU, 32MB SDRAM, 8 MB Flash, (2)10/100 Ethernet Ports, Enclosure is Outdoor UV Plastic, Max Power Consumption 8W, Dimension 294x31x80, included 24V, 0.5A PoE Adapter, Pole Mount Kit Included
Ubiquiti Networks BulletM2-TI (BM2-TI), 2,4Ghz 802.11b/g/n 28dBm Outdoor Wireless Radio without Antena (integrated N-type antena connector). Throughput 100+ Mbps. Range depends on Antena used. Used as an Access Point, Client, or Bridge for Point-to-Point or Point-to-MultiPoint applications. Atheros MIPS 24KC, 400MHz CPU, 32MB SDRAM, 8MB Flash, (1)10/100 Ethernet Port, Antena Connector Type: N-type Male Jack, Compatible with any Antenna with a Type N female connector. 24V, 0.5A PoE Adapter (included) (Non 802.3af). Max Power Consumption 7W, Housing Indstrial Strength Titanium Aluminum. Dimension 190x46mm.
MikroTik RB912UAG-2HPnD-OUT, (BaseBox2) Outdoor 2.4Ghz 802.11b/g/n wireless device in a weatherproof enclosure with two SMA connectors for antenas and a cable hood for protection against moisture. Max TX Power 30 dBm, Atheros AR9342 600MHz CPU, 64MB DDR onboard memory, (1) 1000Mbit Gigabit RJ45 port, (1) miniPCIe slot for adding an additional 802.11 wireless card or 3G, (1) USB 2.0 port, (2)RP-SMA Female Connectors (outside thread) to connect extrenal antenas. Power Option: PoE: 8-30V DC on Ether1 (Non 802.3af). Consumption: 14W at 24V, Includes RB912 outdoor unit, 24V 0.8A Power Adapter, PoE injector, mounting loop, DIN rail mount, mounting ring, RouterOS, Level4 license. Also available are three additional places for antenna connectors, in case you wish to use the BaseBox miniPCIe slot for one more wireless interface to make a dual band device, or a 3G/4G modem. Wireless Modes AP/Wireless Client/Bridge. Dimension 246x135x50mm
Ubiqiuiti Networks RM2-TI (RocketM2 Titanium), 2.4Ghz 28dBm Wireless 802.11g/n Outdoor AP/Basestation Radio (without Antenna) in a Rugged Weatherproof Die-Cast Aluminum Enclosure, Throughput 150+ Mbps Range 50+ km. Can be used for PtP bridging or PtMP (AP or Basestation). Atheros 74KC, 550 MHz CPU, 128 MB SDRAM, 8 MB Flash, (1)1000 Mbit/s GigabitEthernet Port + (1)10/100Mbit/s Port, (2)RP-SMA (Waterproof) antena connectors, Antena sold seperate. Mounting kit included, 48V, 0,5A PoE Adapter included (802.3af compliant), Max Power consumption 6.5W, Includes Ubiquiti AirMax TDMA technology and AirOS web management software. Compatible with antenas AM-V2G-Ti, AM-2G15-120, AM-2G16-90, RD-2G24, AMO-2G10, AMO-2G13
Ubiquiti Networks AF-2X, airFiber 2,4 GHz Carrier Backhaul Radio, designed for long-range, Point-to-Point (PtP) backhaul links. It features the highest TDD throughput available and proprietary HDD for ultra-low latency, 500+ Mbps Throughput, 200+km Range, GPS Synchronization, 10.6 bps/Hz spectral efficiency. AF-2X supports ± 45° slant polarization for improved noise immunity and Signal-to-Noise Ratio (SNR). It is compatible with Ubiquiti antenna AF-2G24-S45 offering gain of 24 dBi. The compact form factor of the AF-2X allows it to fit into the radio mount of Ubiquiti antennas, so installation requires no special tools. You will need to order two units for a complete link due to its proprietary protocol.
Ubiquiti Networks NBE-M2-13, NanoBeam Outdoor 2,4 GHz MIMO 2x 13dBi Directional Antena with integrated 802.11b/g/n 13dBm Wireless Radio. Throughput 150+Mbps, Range 15+ km. Can be used as wireless client CPE device in Point-to-MultiPoint network, or as a bridge in Point-to-Point Network. Dish Reflector 140mm, Ball joint for aiming. Dual Linear, VSWR 1.5:1, Atheros MIPS 74Kc, 560 MHz CPU, 64 MB DDR2, 8 MB Flash, (1)10/100 Ethernet Port, Dimension 189 x 189 x 125 mm, 24V, 0,5A PoE Adapter included, Max Power Consumption 6W, Wind Survivability 200km/h, Radome shield included, Pole Mount kit included. Wall Mount kit NBE-WMK sold seperate.
MikroTik LHG XL 2 (RBLHG-2nD-XL), 2,4Ghz Long Range compact and light wireless device with an integrated dual polarisation 21 dBi grid antenna. It is perfect for point to point links or for use as a CPE. MIPSBE QCA9533 650MHz CPU. Dimension O 550 x 245 mm. Router OS LVL3.
MikroTik SXTsq Lite2 (RBSXTsq2nD), 2,4Ghz dual chain 10dBi compact and lightweight outdoor wireless device with an integrated antenna. Perfect for point-to-point links or as a CPE unit. It is compact, weatherproof and easy to mount. The SXTsq Lite2 retains a 10 dBi antenna like the SXT Lite2, our previous model, yet the antenna design has been improved and the physical size has been dramatically reduced - the SXTsq is two times thinner.
MikroTik mANTBox 2 12s (RB911G-2HPnD-12S), long range 12dbi 120 degrees integrated Base Station for 2.4 GHz. Comes with the Gigabit Ethernet port and has a built in 802.11 b/g/n Dual-chain wireless RB911 device with up to 30 dBm output power. Unit comes with Gigabit PoE injector, 24V 0.8A power adapter, quickMOUNT PRO mount + metal ring for pole mount, Router OS lvl 4. Polarization Vertical and horizontal. Dimension 140x348x82mm.
TP-Link CPE210 2.4GHz 300Mbps 9dBi Outdoor CPE | CPU: Qualcomm Atheros 560MHz CPU, MIPS 74Kc | Memory: 64MB DDR2 RAM, 8MB Flash | 1x 10/100Mbps Shielded Ethernet Port (LAN0,Passive PoE in), 1x Grounding Terminal, 1x Reset Button | Passive Power over Ethernet via LAN0 (+4,5pins; -7,8pins), Voltage range: 16-27VDC | Power consumption: 5 Watts Max | Dimensions ( W x D x H ): 224 x 79 x 60 mm